Skip to content

Elmira Police Frequencies

We do not have frequencies listed specifically for Elmira in Stark County, Illinois yet. Countywide channels for Stark County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Kewanee IDOC (STARCOM21 Statewide Illinois), about 6 miles away.

About Elmira Police Frequencies

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: STARCOM21 Statewide Illinois: 3 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Elmira, start with the Kewanee IDOC site of STARCOM21 Statewide Illinois, about 6 miles away. Its control channels: 860.9375 MHz.

Stark County channels that also cover Elmira

Tactical

Tactical frequencies for Stark County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Stark County GovernmentCar-to-Car155.8500FMNKSG408
Stark County GovernmentCar-to-Car465.3500FMNKSG408

STARCOM21 Statewide Illinois

STARCOM21 Statewide Illinois talkgroups
AgencyDescriptionTalkgroupHexMode
Stark County SheriffStark County Sheriff – Dispatch66951a27T
Stark County SheriffOperations (Channel 3)66931a25T
Stark County SheriffOperations (Channel 2)66941a26T

Nearest trunked radio sites

Distances are measured from the center of Elmira.

Kewanee IDOC · STARCOM21 Statewide Illinois
RFSS 1 · Site 52 (hex 34) · about 6 mi away
Control 860.9375
Voice 856.9375, 857.9375, 859.9375
Toulon · STARCOM21 Statewide Illinois
RFSS 2 · Site 66 (hex 42) · NAC 140 · about 7 mi away
Control 853.2375
Voice 851.6125, 852.0375, 853.0375, 853.2875, 853.7125
Kewanee 700 · STARCOM21 Statewide Illinois
RFSS 1 · Site 17 (hex 11) · NAC 140 · about 10 mi away
Control 774.34375, 774.78125, 775.09375
Voice 770.96875, 773.04375, 775.30625, 775.55625, 855.9375, 856.3375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.