Skip to content

Noble Police Frequencies

We do not have frequencies listed specifically for Noble in Cass County, Indiana yet. Countywide channels for Cass County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Logansport (Indiana Project Hoosier SAFE-T), about 4 miles away.

About Noble Police Frequencies

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Indiana Project Hoosier SAFE-T: 4 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Noble, start with the Logansport site of Indiana Project Hoosier SAFE-T, about 4 miles away. Its control channels: 857.4875, 859.2125 MHz.

Cass County channels that also cover Noble

Tactical

AgencyDescriptionFrequency (MHz)ToneModeFCC
Cass County SheriffOperations154.7700FMNWPWS755

Jails & Corrections

AgencyDescriptionFrequency (MHz)ToneModeFCC
Indiana FSSA State Hospital - LogansportOperations860.2375
In 815.2375
072 DPLFMNWPIQ344

Indiana Project Hoosier SAFE-T

AgencyDescriptionTalkgroupHexMode
Cass County SheriffCass County Sheriff – Dispatch100572749D
Cass County SheriffOperations10059274bD
Cass County SheriffOperations10060274cD
Cass County SheriffOperations10061274dD

Nearest trunked radio sites

Distances are measured from the center of Noble.

Logansport · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 57 (hex 39) · NAC 6B7 · about 4 mi away
Control 857.4875, 859.2125
Voice 851.9875, 852.9, 853.4875, 858.9375
Monticello · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 65 (hex 41) · NAC 6B5 · about 16 mi away
Control 857.9375, 857.9875
Voice 856.2125, 856.9875, 857.4375
Peru · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 21 (hex 15) · NAC 6BA · about 18 mi away
Control 853.45, 853.975
Voice 851.375, 851.4, 851.9, 852.425
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.