Skip to content

Fairview Police Frequencies

We do not have frequencies listed specifically for Fairview in Fayette County, Indiana yet. Countywide channels for Fayette County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Connersville (Indiana Project Hoosier SAFE-T), about 7 miles away.

About Fairview Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Indiana Project Hoosier SAFE-T: 5 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Fairview, start with the Connersville site of Indiana Project Hoosier SAFE-T, about 7 miles away. Its control channels: 851.8875, 852.3875, 853.725 MHz.

Fayette County channels that also cover Fairview

Dispatch

AgencyDescriptionFrequency (MHz)ToneModeFCC
Fayette County Sheriff BackupFayette County Sheriff – Dispatch151.0550
In 153.9350
245 DPLFMNKSS798

Indiana Project Hoosier SAFE-T

AgencyDescriptionTalkgroupHexMode
Fayette County SheriffFayette County Sheriff – Dispatch1023927ffD
Fayette County SheriffOperations (County)1023027f6D
Fayette County SheriffOperations (County)1023127f7D
Fayette County SheriffOperations (County)1023227f8D
Fayette County SheriffOperations (County)1023327f9D

Nearest trunked radio sites

Distances are measured from the center of Fairview.

Connersville · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 38 (hex 26) · NAC 6B8 · about 7 mi away
Control 851.8875, 852.3875, 853.725
Voice 851.2, 851.45
Rushville · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 76 (hex 4C) · NAC 6B9 · about 10 mi away
Control 852.9625, 853.4625
Voice 851.4875, 851.9625, 852.4625
Knightstown · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 94 (hex 5E) · NAC 6B4 · about 16 mi away
Control 774.43125, 774.68125
Voice 769.81875, 770.26875, 770.81875, 771.54375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.