Skip to content

Pike Police Frequencies

We do not have frequencies listed specifically for Pike in Jay County, Indiana yet. Countywide channels for Jay County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Redkey (Indiana Project Hoosier SAFE-T), about 10 miles away.

About Pike Police Frequencies

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Indiana Project Hoosier SAFE-T: 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Pike, start with the Redkey site of Indiana Project Hoosier SAFE-T, about 10 miles away. Its control channels: 853.8875, 855.2375 MHz.

Jay County channels that also cover Pike

Dispatch

AgencyDescriptionFrequency (MHz)ToneModeFCC
Jay County Law EnforcementJay County Law Enforcement – Dispatch155.3100
In 154.7700
131.8 PLFMNWNAU890

Tactical

AgencyDescriptionFrequency (MHz)ToneModeFCC
Jay County Law EnforcementJay County Law Enforcement – Tactical Channel154.0550FMNWPKS462

Indiana Project Hoosier SAFE-T

AgencyDescriptionTalkgroupHexMode
Jay County SheriffJay County Sheriff – Dispatch108022a32D

Nearest trunked radio sites

Distances are measured from the center of Pike.

Redkey · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 23 (hex 17) · NAC 6B3 · about 10 mi away
Control 853.8875, 855.2375
Voice 851.8875, 852.9875, 853.0625, 853.3625
Union City · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 70 (hex 46) · NAC 6B0 · about 13 mi away
Control 853.45, 853.925
Voice 851.9875, 852.475
Simulcast · Randolph County Government
RFSS 1 · Site 1 (hex 1) · NAC 42C · about 15 mi away
Control 769.75625, 771.23125, 771.48125, 771.75625, 772.93125
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.