Skip to content

San Pierre Police Frequencies

We do not have frequencies listed specifically for San Pierre in Starke County, Indiana yet. Countywide channels for Starke County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Medaryville (Indiana Project Hoosier SAFE-T), about 4 miles away.

About San Pierre Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Indiana Project Hoosier SAFE-T: 5 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For San Pierre, start with the Medaryville site of Indiana Project Hoosier SAFE-T, about 4 miles away. Its control channels: 853.425, 853.925 MHz.

Starke County channels that also cover San Pierre

Tactical

AgencyDescriptionFrequency (MHz)ToneModeFCC
Starke County SheriffMounted Sheriff's Posse155.5000FMN—

Indiana Project Hoosier SAFE-T

AgencyDescriptionTalkgroupHexMode
Starke County SheriffStarke County Sheriff – Dispatch12300300cD
Starke County SheriffStarke County Sheriff – Dispatch12301300dD
Starke County SheriffOperations12302300eD
Starke County SheriffOperations12303300fD
Starke County SheriffOperations123043010D

Nearest trunked radio sites

Distances are measured from the center of San Pierre.

Medaryville · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 17 (hex 11) · NAC 6B7 · about 4 mi away
Control 853.425, 853.925
Voice 851.425, 851.925, 852.925
Bass Lake · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 61 (hex 3D) · NAC 6B1 · about 15 mi away
Control 853.3375, 853.7375
Voice 851.3625, 852.3625, 853.0875
Rensselaer · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 91 (hex 5B) · NAC 6BF · about 16 mi away
Control 854.9875, 859.9375
Voice 851.625, 852.75, 853.65
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.