Skip to content

Washington Police Frequencies

We do not have frequencies listed specifically for Washington in Warren County, Indiana yet. Countywide channels for Warren County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Attica (Indiana Project Hoosier SAFE-T), about 6 miles away.

About Washington Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Indiana Project Hoosier SAFE-T: 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Washington, start with the Attica site of Indiana Project Hoosier SAFE-T, about 6 miles away. Its control channels: 853.4375, 853.9375 MHz.

Warren County channels that also cover Washington

Dispatch

Dispatch frequencies for Warren County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Fire/EMS/Emergency Management BackupFire/EMS/Emergency Management – Dispatch (Williamsport)859.6375
In 814.6375
186.2 PLFMNWQYG207

Indiana Project Hoosier SAFE-T

Indiana Project Hoosier SAFE-T talkgroups
AgencyDescriptionTalkgroupHexMode
Warren County SheriffCar-to-Car124333091D
Warren County SheriffOperations124343092D

Nearest trunked radio sites

Distances are measured from the center of Washington.

Attica · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 67 (hex 43) · NAC 6B8 · about 6 mi away
Control 853.4375, 853.9375
Voice 851.4125, 851.9125, 852.9125, 856.2375
Covington · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 26 (hex 1A) · NAC 6B6 · about 10 mi away
Control 853.3625, 853.9
Voice 851.3625, 852.3625, 852.8625, 855.2375
Simulcast · Tippecanoe County Government (P25)
Project 25 · RFSS 1 · Site 1 (hex 1) · NAC 6F1 · about 24 mi away
Control 851.05, 853.8375, 857.7375
Voice 851.85, 852.7125, 853.1125, 853.5875, 855.2125, 855.7375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.