About Roseville Police Frequencies
- Trunked radio systems that carry law-enforcement traffic here: Iowa Statewide Interoperable Communications System (ISICS): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
- To follow a trunked system, program a control channel first. For Roseville, start with the Floyd Co Simulcast site of Iowa Statewide Interoperable Communications System (ISICS), about 3 miles away. Its control channels: 774.33125 MHz.
Floyd County channels that also cover Roseville
Iowa Statewide Interoperable Communications System (ISICS)
| Agency | Description | Talkgroup | Hex | Mode |
|---|---|---|---|---|
| Floyd County Sheriff | Law 1 | 29701 | 7405 | T |
Nearest trunked radio sites
Distances are measured from the center of Roseville.
Floyd Co Simulcast · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 2 · Site 34 (hex 22) · about 3 mi away
Control 774.33125
Voice 773.58125, 773.83125
Butler · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 2 · Site 12 (hex C) · about 20 mi away
Voice 774.34375
Mason City · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 1 · Site 65 (hex 41) · NAC 4C4 · about 21 mi away
Control 769.90625, 770.15625, 770.40625
Voice 769.65625
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.