Skip to content

Union Police Frequencies

We do not have frequencies listed specifically for Union in Washington County, Kansas yet. Countywide channels for Washington County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Haddam (Kansas Statewide Interoperable Communication System (KSICS)), about 11 miles away.

About Union Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Kansas Statewide Interoperable Communication System (KSICS): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Union, start with the Haddam site of Kansas Statewide Interoperable Communication System (KSICS), about 11 miles away. Its control channels: 852.4625, 852.725 MHz.

Washington County channels that also cover Union

Tactical

Tactical frequencies for Washington County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Washington County SheriffCar-to-Car153.8300151.4 PLFMNWPLS377

Kansas Statewide Interoperable Communication System (KSICS)

Kansas Statewide Interoperable Communication System (KSICS) talkgroups
AgencyDescriptionTalkgroupHexMode
Washington County SheriffWashington County Sheriff – Dispatch480612c6D

Nearest trunked radio sites

Distances are measured from the center of Union.

Haddam · Kansas Statewide Interoperable Communication System (KSICS)
RFSS 2 · Site 19 (hex 13) · NAC 1B4 · about 11 mi away
Control 852.4625, 852.725
Voice 851.8375, 852.975, 853.4, 853.8625
KSU Campus · Riley County
RFSS 37 · Site 37 (hex 25) · NAC 025 · about 36 mi away
Control 856.0125, 856.9375, 857.7625, 858.2625, 858.7625, 859.2625, 859.9375
Blue Rapids · Kansas Statewide Interoperable Communication System (KSICS)
RFSS 2 · Site 11 (hex B) · about 38 mi away
Control 852.1125, 852.4125
Voice 851.8, 852.75, 853.475, 853.9
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.