Skip to content

Pleasant Police Frequencies

We do not have frequencies listed specifically for Pleasant in Hanson County, South Dakota yet. Countywide channels for Hanson County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Mitchell (South Dakota State Radio System), about 19 miles away.

About Pleasant Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: South Dakota State Radio System: 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Pleasant, start with the Mitchell site of South Dakota State Radio System, about 19 miles away. Its control channels: 159, 159.255, 159.84 MHz.

Hanson County channels that also cover Pleasant

Talk-around & Car-to-Car

AgencyDescriptionFrequency (MHz)ToneModeFCC
Hanson County SheriffHanson County Sheriff – Alternate460.0750
In 465.0750
210.7 PLFMWQBT236

South Dakota State Radio System

AgencyDescriptionTalkgroupHexMode
Hanson County SheriffHanson County Sheriff – Dispatch1431597D
Hanson County SheriffSheriff Talk1432598D

Nearest trunked radio sites

Distances are measured from the center of Pleasant.

Mitchell · South Dakota State Radio System
RFSS 1 · Site 11 (hex B) · NAC 470 · about 19 mi away
Control 159, 159.255, 159.84
Voice 155.64, 156.12, 159.45
Turkey Ridge · South Dakota State Radio System
RFSS 1 · Site 15 (hex F) · NAC 47F · about 31 mi away
Control 157.95, 159.375, 159.945
Voice 157.83
Madison · South Dakota State Radio System
RFSS 1 · Site 28 (hex 1C) · NAC 47C · about 34 mi away
Control 159.78, 160.065
Voice 159.54, 159.915
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.