Skip to content

Dancyville Police Frequencies

We do not have frequencies listed specifically for Dancyville in Haywood County, Tennessee yet. Countywide channels for Haywood County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Whiteville (Tennessee Advanced Communications Network (TACN)), about 10 miles away.

About Dancyville Police Frequencies

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Haywood County Public Safety: 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Dancyville, start with the Whiteville site of Tennessee Advanced Communications Network (TACN), about 10 miles away. Its control channels: 769.53125, 771.53125, 773.30625 MHz.
  • 1 listed entry is marked encrypted. No scanner can decode encrypted audio.

Haywood County channels that also cover Dancyville

Dispatch

AgencyDescriptionFrequency (MHz)ToneModeFCC
Haywood County Sheriff OldHaywood County Sheriff – Dispatch460.1125
In 465.1125
FMNWPUU348
Haywood County Sheriff OldHaywood County Sheriff – Dispatch460.4750
In 465.4750
127.3 PLFMNKXM609

Haywood County Public Safety

1 encrypted talkgroup (cannot be monitored)
AgencyDescriptionTalkgroupHexMode
Haywood County Sheriff BackupHaywood County Sheriff – Dispatch1066aT

Nearest trunked radio sites

Distances are measured from the center of Dancyville.

Whiteville · Tennessee Advanced Communications Network (TACN)
RFSS 4 · Site 30 (hex 1E) · NAC 2AB · about 10 mi away
Control 769.53125, 771.53125, 773.30625, 774.03125, 774.28125
Voice 771.13125, 772.60625
Dancyville · Haywood County Public Safety
Site 2 (hex 2) · about 13 mi away
Voice 453.1625, 453.7
Brownsville · Haywood County Public Safety
Site 1 (hex 1) · about 13 mi away
Voice 453.6875, 460.1125
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.