Skip to content

Wright Police Frequencies

We do not have frequencies listed specifically for Wright in Campbell County, Wyoming yet. Countywide channels for Campbell County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Wright (WyoLink), about 1 miles away.

About Wright Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: WyoLink: 7 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Wright, start with the Wright site of WyoLink, about 1 miles away. Its control channels: 154.13, 154.25 MHz.

Campbell County channels that also cover Wright

Dispatch

Dispatch frequencies for Campbell County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Campbell County SheriffCampbell County Sheriff154.8450
In 155.6850
107.2 PLFMNKNEQ797

WyoLink

WyoLink talkgroups
AgencyDescriptionTalkgroupHexMode
Campbell County SheriffSheriff 1149073a3bD
Campbell County SheriffSheriff 2149083a3cD
Campbell County SheriffCampbell County Sheriff – Tactical Channel149143a42D
Campbell County SheriffCampbell County Sheriff – Tactical Channel149153a43D
Campbell County SheriffSheriff Investigations149133a41D
Campbell County SheriffSheriff SP149173a45D
Campbell County SheriffSheriff Jail149163a44D

Nearest trunked radio sites

Distances are measured from the center of Wright.

Wright · WyoLink
RFSS 2 · Site 37 (hex 25) · NAC 1A0 · about 1 mi away
Control 154.13, 154.25
Voice 154.7025, 154.9275, 155.0475
Pumpkin Buttes · WyoLink
RFSS 2 · Site 17 (hex 11) · NAC 1A9 · about 19 mi away
Control 151.0175, 154.0175, 155.4975
Voice 154.1975, 169.7125
Lone Tree · WyoLink
RFSS 2 · Site 18 (hex 12) · NAC 1A9 · about 25 mi away
Control 151.04, 151.0775
Voice 151.31, 154.16, 154.6725
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency do the police use in Wright?

We do not have a dispatch channel listed specifically for Wright. County-level dispatch channels in the same county: Campbell County Sheriff 154.8450 MHz (107.2 PL).