About Linsell Police Frequencies
- Trunked radio systems that carry law-enforcement traffic here: Allied Radio Matrix for Emergency Response (ARMER): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
- To follow a trunked system, program a control channel first. For Linsell, start with the Gatzke site of Allied Radio Matrix for Emergency Response (ARMER), about 3 miles away. Its control channels: 851.1375, 851.8125 MHz.
Marshall County channels that also cover Linsell
Allied Radio Matrix for Emergency Response (ARMER)
| Agency | Description | Talkgroup | Hex | Mode |
|---|---|---|---|---|
| Marshall County Sheriff | Marshall Law Dispatch | 51300 | c864 | D |
Nearest trunked radio sites
Distances are measured from the center of Linsell.
Gatzke · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 6 · Site 15 (hex F) · about 3 mi away
Control 851.1375, 851.8125
Voice 852.65, 853.1375, 854.1625
Skime · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 6 · Site 14 (hex E) · about 12 mi away
Control 853.1125, 854.0625
Voice 851.4625, 852.0375, 852.875
Middle River · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 6 · Site 86 (hex 56) · about 19 mi away
Control 851.0875, 853.4125
Voice 851.9875, 853.9, 854.1125
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.