Skip to content

Cedar Police Frequencies

We do not have frequencies listed specifically for Cedar in Martin County, Minnesota yet. Countywide channels for Martin County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Sherburn (Allied Radio Matrix for Emergency Response (ARMER)), about 10 miles away.

About Cedar Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Allied Radio Matrix for Emergency Response (ARMER): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Cedar, start with the Sherburn site of Allied Radio Matrix for Emergency Response (ARMER), about 10 miles away. Its control channels: 851.975, 852.975 MHz.

Martin County channels that also cover Cedar

Dispatch

Dispatch frequencies for Martin County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Martin County SheriffSheriff's Department155.0700
In 155.4150
156.7 PLFMNKAF531

Allied Radio Matrix for Emergency Response (ARMER)

Allied Radio Matrix for Emergency Response (ARMER) talkgroups
AgencyDescriptionTalkgroupHexMode
Martin County SheriffLaw Enforcement Dispatch3481287fcD

Nearest trunked radio sites

Distances are measured from the center of Cedar.

Sherburn · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 3 · Site 76 (hex 4C) · about 10 mi away
Control 851.975, 852.975
Voice 851.3625, 852.375, 856.2625, 856.7625
Mountain Lake · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 2 · Site 35 (hex 23) · about 11 mi away
Control 857.2625, 858.2625
Voice 852.1, 853.125, 853.875
Windom · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 2 · Site 30 (hex 1E) · about 16 mi away
Control 853.175, 857.2125
Voice 852.175, 855.4875, 856.7125
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency do the police use in Cedar?

We do not have a dispatch channel listed specifically for Cedar. County-level dispatch channels in the same county: Martin County Sheriff 155.0700 MHz (156.7 PL).