Skip to content

Mesic Police Frequencies

We do not have frequencies listed specifically for Mesic in Pamlico County, North Carolina yet. Countywide channels for Pamlico County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Bayboro (North Carolina VIPER), about 8 miles away.

About Mesic Police Frequencies

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: North Carolina VIPER: 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Mesic, start with the Bayboro site of North Carolina VIPER, about 8 miles away. Its control channels: 852.9, 853.4625 MHz.

Pamlico County channels that also cover Mesic

Dispatch

Dispatch frequencies for Pamlico County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pamlico County SheriffPamlico County Sheriff Dispatch154.8000
In 155.5200
218.1 PLFMWNQN968

Tactical

Tactical frequencies for Pamlico County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pamlico County SheriffPamlico County Sheriff155.970097.4 PLFMWNQN968

North Carolina VIPER

North Carolina VIPER talkgroups
AgencyDescriptionTalkgroupHexMode
Pamlico County SheriffPamlico Sheriff3500488bcD
Pamlico County SheriffPamlico NARC3500688beD

Nearest trunked radio sites

Distances are measured from the center of Mesic.

Bayboro · North Carolina VIPER
RFSS 3 · Site 5 (hex 5) · NAC 1F1 · about 8 mi away
Control 852.9, 853.4625
Voice 851.3875, 851.8875, 852.45, 857.4875, 857.7625
Bath · North Carolina VIPER
RFSS 3 · Site 4 (hex 4) · NAC 1F2 · about 22 mi away
Control 852.55, 855.4625
Voice 851.1375, 851.6, 852.1625, 853.8625
Rose Bay · North Carolina VIPER
RFSS 3 · Site 55 (hex 37) · NAC 1F1 · about 23 mi away
Control 852.4625, 853.8875
Voice 851.4125, 851.95, 856.6125
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency do the police use in Mesic?

We do not have a dispatch channel listed specifically for Mesic. County-level dispatch channels in the same county: Pamlico County Sheriff 154.8000 MHz (218.1 PL).