Skip to content

Rich Valley Police Frequencies

We do not have frequencies listed specifically for Rich Valley in Benson County, North Dakota yet. Countywide channels for Benson County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Devils Lake (North Dakota Statewide Interoperable Radio Network (SIRN 20/20)), about 37 miles away.

About Rich Valley Police Frequencies

We don't have any verified police frequencies for Rich Valley yet, but we're working on adding some.

If you know of any, or spot something wrong on a nearby page, please send it to contact@police-frequencies.com and we'll check it against the official records.

Nearest trunked radio sites

Distances are measured from the center of Rich Valley.

Devils Lake · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 97 (hex 61) · NAC A64 · about 37 mi away
Control 853.8375
Voice 853.3875, 853.6125
Pickardville · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 58 (hex 3A) · about 40 mi away
Control 853.9125
Voice 853.4625, 853.6875
Denhoff · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 12 (hex C) · NAC A6B · about 44 mi away
Control 853.5875, 853.8125
Voice 853.3625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.