Skip to content

Kimball Police Frequencies

We do not have frequencies listed specifically for Kimball in Iron County, Wisconsin yet. Countywide channels for Iron County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Mercer (WISCOM), about 17 miles away.

About Kimball Police Frequencies

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • 2 conventional channels use a digital mode (P25), which needs a scanner that decodes that mode.
  • Trunked radio systems that carry law-enforcement traffic here: WISCOM: 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Kimball, start with the Mercer site of WISCOM, about 17 miles away. Its control channels: 139.2625, 139.6625, 151.385 MHz.
  • 2 listed entries are marked encrypted. No scanner can decode encrypted audio.

Iron County channels that also cover Kimball

Dispatch

AgencyDescriptionFrequency (MHz)ToneModeFCC
Iron County SheriffNorth159.0900
In 154.9500
NAC 103P25 KSB845
Iron County SheriffSouth159.0900
In 154.9500
NAC 103P25 KSB845
Iron County SheriffNorth (103.5 in)159.0900
In 154.9500
103.5 PLFMNKSB845
Iron County SheriffSouth (110.9 in)159.0900
In 154.9500
103.5 PLFMNKSB845

Jails & Corrections

AgencyDescriptionFrequency (MHz)ToneModeFCC
Iron County SheriffSheriff Jail151.6850205 DPLFMNNONE

WISCOM

AgencyDescriptionTalkgroupHexMode
Iron County SheriffIron County Sheriff's Office260016591D

Nearest trunked radio sites

Distances are measured from the center of Kimball.

Mercer · WISCOM
RFSS 1 · Site 64 (hex 40) · NAC B09 · about 17 mi away
Control 139.2625, 139.6625, 151.385
Voice 154.755, 155.025
Mellen · WISCOM
RFSS 1 · Site 63 (hex 3F) · NAC B06 · about 22 mi away
Control 139.0875, 152.0375, 152.7875
Voice 151.235, 154.385
Hillside · WISCOM
RFSS 1 · Site 122 (hex 7A) · NAC B03 · about 33 mi away
Control 151.1825, 151.2275, 151.295, 151.3375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency do the police use in Kimball?

We do not have a dispatch channel listed specifically for Kimball. County-level dispatch channels in the same county: Iron County Sheriff 159.0900 MHz (NAC 103); Iron County Sheriff 159.0900 MHz (NAC 103); Iron County Sheriff 159.0900 MHz (103.5 PL); Iron County Sheriff 159.0900 MHz (103.5 PL).