Skip to content

Vernon Police Frequencies

We do not have frequencies listed specifically for Vernon in Jackson County, Indiana yet. Countywide channels for Jackson County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Seymour (Indiana Project Hoosier SAFE-T), about 10 miles away.

About Vernon Police Frequencies

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: Indiana Project Hoosier SAFE-T: 3 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Vernon, start with the Seymour site of Indiana Project Hoosier SAFE-T, about 10 miles away. Its control channels: 853.9125 MHz.

Jackson County channels that also cover Vernon

Jails & Corrections

AgencyDescriptionFrequency (MHz)ToneModeFCC
Jackson County SheriffJail154.7400
In 158.7300
FMNWPQJ422
Jackson County SheriffJuvenile Detention Center155.6250
In 158.9700
043 DPLFMNWPQJ422

Indiana Project Hoosier SAFE-T

AgencyDescriptionTalkgroupHexMode
Jackson County SheriffJackson County Sheriff – Dispatch213855389D
Jackson County SheriffSheriff Operations21386538aD
Jackson County SheriffSheriff Operations21387538bD

Nearest trunked radio sites

Distances are measured from the center of Vernon.

Seymour · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 32 (hex 20) · NAC 6B9 · about 10 mi away
Control 853.9125
Voice 851.4625, 852.4125, 852.8875, 853.3625, 856.7125
Brownstown · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 49 (hex 31) · NAC 6B4 · about 12 mi away
Control 854.3875
Voice 851.225, 852.9375, 853.0375, 853.2875, 854.1125
Fleenortown · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 50 (hex 32) · NAC 6B8 · about 14 mi away
Control 853.4625, 855.7125
Voice 851.3125, 851.725, 852.95
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.