Skip to content

Redpath Police Frequencies

We do not have frequencies listed specifically for Redpath in Traverse County, Minnesota yet. Countywide channels for Traverse County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Wheaton (Allied Radio Matrix for Emergency Response (ARMER)), about 11 miles away.

About Redpath Police Frequencies

  • Trunked radio systems that carry law-enforcement traffic here: Allied Radio Matrix for Emergency Response (ARMER): 3 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Redpath, start with the Wheaton site of Allied Radio Matrix for Emergency Response (ARMER), about 11 miles away. Its control channels: 859.7625, 860.7625 MHz.
  • 2 listed entries are marked encrypted. No scanner can decode encrypted audio.

Traverse County channels that also cover Redpath

Allied Radio Matrix for Emergency Response (ARMER)

AgencyDescriptionTalkgroupHexMode
Traverse County SheriffLaw Dispatch267086854D
2 encrypted talkgroups (cannot be monitored)
AgencyDescriptionTalkgroupHexMode
Traverse County SheriffLaw Tactical267096855D
Traverse County SheriffLaw Tactical267106856D

Nearest trunked radio sites

Distances are measured from the center of Redpath.

Wheaton · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 4 · Site 18 (hex 12) · NAC 40B · about 11 mi away
Control 859.7625, 860.7625
Voice 855.9625, 856.7625, 857.7625, 858.7625
Herman · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 4 · Site 7 (hex 7) · NAC 408 · about 11 mi away
Control 857.4625, 859.4625
Voice 851.125, 855.4625, 856.9375, 858.4625, 860.4625
Nashua · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 4 · Site 25 (hex 19) · NAC 40e · about 13 mi away
Control 852.4, 852.9
Voice 851.95, 853.5, 859.2625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.