Skip to content

Garland Police Frequencies

We do not have frequencies listed specifically for Garland in Sampson County, North Carolina yet. Countywide channels for Sampson County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Taylors Bridge (North Carolina VIPER), about 10 miles away.

About Garland Police Frequencies

  • Trunked radio systems that carry law-enforcement traffic here: North Carolina VIPER: 6 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Garland, start with the Taylors Bridge site of North Carolina VIPER, about 10 miles away. Its control channels: 853.075, 853.325 MHz.
  • 3 listed entries are marked encrypted. No scanner can decode encrypted audio.

Sampson County channels that also cover Garland

North Carolina VIPER

AgencyDescriptionTalkgroupHexMode
Sampson County SheriffSampson County Sheriff – Dispatch41512a228D
Sampson County SheriffSampson SID41516a22cD
Sampson County SheriffSampson Command Staff41509a225D
3 encrypted talkgroups (cannot be monitored)
AgencyDescriptionTalkgroupHexMode
Sampson County SheriffSampson CID41511a227D
Sampson County SheriffSheriffs Office HEAT41513a229D
Sampson County SheriffSampson Patrol41514a22aD

Nearest trunked radio sites

Distances are measured from the center of Garland.

Taylors Bridge · North Carolina VIPER
RFSS 3 · Site 65 (hex 41) · NAC 1F0 · about 10 mi away
Control 853.075, 853.325
Voice 851.175, 851.4875, 851.9, 852.55, 852.85
Lagoon · North Carolina VIPER
RFSS 3 · Site 40 (hex 28) · NAC 1F0 · about 15 mi away
Control 771.88125, 772.78125
Voice 769.08125, 769.75625, 770.55625, 771.18125, 771.48125
Salemburg · North Carolina VIPER
RFSS 3 · Site 56 (hex 38) · NAC 1F3 · about 18 mi away
Control 852.775, 853.875
Voice 851.55, 851.8625, 852.4375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.