Skip to content

Maxton Police Frequencies

We do not have frequencies listed specifically for Maxton in Scotland County, North Carolina yet. Countywide channels for Scotland County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Laurinburg (North Carolina VIPER), about 5 miles away.

Maxton also extends into Robeson County.

About Maxton Police Frequencies

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry law-enforcement traffic here: North Carolina VIPER: 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Maxton, start with the Laurinburg site of North Carolina VIPER, about 5 miles away. Its control channels: 855.9875, 856.4625 MHz.

Scotland County channels that also cover Maxton

Dispatch

Dispatch frequencies for Scotland County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Scotland County SheriffScotland County Sheriff – Dispatch453.4000
In 458.4000
141.3 PLFMKIF920
Scotland County SheriffScotland County Sheriff – Dispatch453.7000
In 458.7000
141.3 PLFMKIF920
Scotland County SheriffScotland County Sheriff – Dispatch460.4250
In 465.4250
FMWPLZ582

North Carolina VIPER

North Carolina VIPER talkgroups
AgencyDescriptionTalkgroupHexMode
Scotland County SheriffSheriffs Office42004a414D

Nearest trunked radio sites

Distances are measured from the center of Maxton.

Laurinburg · North Carolina VIPER
RFSS 1 · Site 25 (hex 19) · NAC 1F1 · about 5 mi away
Control 855.9875, 856.4625
Voice 851.25, 851.725, 852.1625, 852.825, 853.1, 853.45
Proctorville · North Carolina VIPER
RFSS 3 · Site 52 (hex 34) · NAC 1F0 · about 16 mi away
Control 852.975, 853.825
Voice 851.375, 851.7125, 852.575
Lumberton UNCTV · North Carolina VIPER
RFSS 3 · Site 39 (hex 27) · about 18 mi away
Control 856.8375, 858.0125
Voice 851.6125, 852.125, 852.4125, 853.1875, 853.9125, 854.0375, 856.2375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency do the police use in Maxton?

We do not have a dispatch channel listed specifically for Maxton. County-level dispatch channels in the same county: Scotland County Sheriff 453.4000 MHz (141.3 PL); Scotland County Sheriff 453.7000 MHz (141.3 PL); Scotland County Sheriff 460.4250 MHz.