Skip to content

Clayton Police Frequencies

We do not have frequencies listed specifically for Clayton in Burke County, North Dakota yet. Countywide channels for Burke County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Columbus (North Dakota Statewide Interoperable Radio Network (SIRN 20/20)), about 12 miles away.

About Clayton Police Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.

Burke County channels that also cover Clayton

Tactical

AgencyDescriptionFrequency (MHz)ToneModeFCC
Burke County SheriffSheriff / Roads / Busses154.0550
In 153.7400
FMNKBF912

Nearest trunked radio sites

Distances are measured from the center of Clayton.

Columbus · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 11 (hex B) · NAC A60 · about 12 mi away
Control 852.0875, 852.3125
Voice 851.8125
Crosby · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 0 · Site 213 (hex D5) · about 32 mi away
Voice 851.9375, 852.2125, 852.4375
Mohall · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 30 (hex 1E) · NAC A6D · about 36 mi away
Control 852.1125, 852.3375
Voice 851.8375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.