About Wellington Police Frequencies
Quick answer: County-level dispatch that covers Wellington: Piscataquis County Sheriff 155.0250 MHz, narrow FM, 192.8 PL.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Piscataquis County channels that also cover Wellington
Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Piscataquis County Sheriff | Piscataquis County Sheriff – Dispatch | 155.0250 In 153.8450 | 192.8 PL | FMN | WGI540 |
Nearest trunked radio sites
Distances are measured from the center of Wellington.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency do the police use in Wellington?
We do not have a dispatch channel listed specifically for Wellington. The county sheriff's dispatch channels in the same county: Piscataquis County Sheriff 155.0250 MHz, narrow FM, 192.8 PL.
What scanner do I need to listen to police in Wellington?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Wellington?
For Wellington, start with the Garland DOT site of Maine State Communications Network (MSCommNet). Its control channels are 152.0975, 160.53, 160.65, 160.95 MHz. Program a control channel first; the scanner finds the voice channels from it.