Before you start
You need three things from a county or city page on this site:
- The system type, such as P25 Phase I, P25 Phase II, Motorola Type II, DMR or NXDN. Your scanner must support it. See conventional, trunked and digital.
- A site that reaches your location, with its control channels.
- The talkgroups you want to hear.
Every scanner menu is different, so this guide uses the general steps. Your scanner's manual or its programming software has the exact button presses.
Step 1: Pick the site
A trunked system has many towers. Choose the one that covers where you will listen.
- On a county page, the site cards list each site's name and control channels. A city page may show the nearest sites to the town.
- If two sites are near you, program both. Your scanner will lock to whichever is stronger.
- If you are travelling, program the sites along your route, or use a scanner that picks sites by location.
Step 2: Create the system
In your scanner or its software, add a new trunked system.
- Set the system type to match the listing.
- Give it a name you will recognise, for example the system and county.
- Leave the NAC on automatic unless you have a reason to set it. See what NAC and RFSS mean.
Step 3: Add the site and its control channels
Add a site to the system and enter every control channel from the listing. Frequencies are in MHz, for example 851.7375.
- Enter all of them, not just the first. A site can move its control channel to another frequency on its list.
- Enter the control frequencies only. The voice frequencies are found by your scanner from the control channel.
Step 4: Add talkgroups
Add the talkgroups you want to hear, using the talkgroup number from the listing.
- Check whether your scanner wants decimal or hex. We show both, so copy the right one. Entering a decimal number in a hex field will point you at the wrong talkgroup.
- Give each talkgroup a short label, such as the alpha tag.
- Skip talkgroups that carry the Enc badge. They are encrypted and will be silent. See encrypted police radio.
Start small. Choosing a few dispatch talkgroups is better than enabling hundreds and listening to a busy system you don't need.
Step 5: Test it
Switch to the system and scan. You should see the scanner lock onto a control channel within a few seconds, then hear calls on the talkgroups you enabled.
Quiet systems can take a while to produce a call. Test during the day, when more people are working.
If you hear nothing
| Symptom | Likely cause |
|---|---|
| The scanner never finds the control channel | You are out of range of that site, or the frequencies were entered wrong |
| It locks, but hears no calls | The talkgroups are wrong, or you used decimal where hex was needed |
| You hear calls but they are garbled or silent | The talkgroup is encrypted, or the system is Phase II and your scanner is not |
| You hear a different system | Two systems share a frequency. Set the NAC to the listed value |
| It worked and then stopped | The system changed. See why a frequency stopped working |
Tips
- Signal first. A trunked system needs a decent control channel signal. An outside or higher antenna helps more than any setting.
- Keep a short list. One site, a few talkgroups, and add more once it works.
- Check the date. Systems are re-programmed. If a talkgroup goes quiet for weeks, check whether it moved.
Frequently asked questions
Do I need to enter every voice frequency?
No. Enter the control channels only. Your scanner learns the voice frequencies from the control channel.
What if I live between two sites?
Program both. A scanner follows the one it can hear best.
Can I use the same talkgroups on every site?
Usually yes. A talkgroup belongs to the system, not to a tower, so the same number works on any site that carries it.
Why do some talkgroups show no audio?
They may be encrypted, quiet at that time of day, or not carried on the site you chose.